nozzle

Trouble Shooting Spray Guns

Trouble Shooting Spray Guns Trouble shooting spray guns tutorial covers the many different types of spray guns that are used for a variety of purposes, many times the problems that they have are similar in many ways. I have compiled this troubleshooter guide from spray gun manufacturers, my experience, qualified Spraygun repairmen, and many other resources. by Gary Kinsey R&E Paint Supply Sales Rep. All Paint guns are not created equal. There are many different types of Spray guns that are used for a variety of purposes. However, many times the problems that they have are similar in many ways. Spray gun Read more

Iwata HP-C Airbrush

Iwata HP-C Airbrush Iwata HP-C airbrush tutorial covers putting the Iwata HP-C back together again after taking it apart to clean it, It’s easy taking airbrushes apart to clean them but sometimes a bit difficult to get back together.  I put this article together for those that own Iwata HP-C  or the like  as this holds true with most Iwata gravity feed airbrushes.   Well getting your Iwata HP-C apart was no problem :-), now you have to put it back together so it works correctly. Below I have listed the steps you would take to do that. This also Read more

Paasche VL Airbrush

Paasche VL Airbrush Passche VL airbrush is an overview of the double action Paasche VL airbrush for those folks who run into trouble putting the VL back together after taking it apart to clean it. Airbrushs are easily taken apart but more often than not hard to get back together .Here’s how to get your VL back together. Thanks to Dr Doom for allowing me to use this VL he won in our tech tip contest on the airbrush forum.   So you have taken your VL apart, cleaned it now its time to put it back together. Below is Read more

Fixing a Airbrush Broken Fluid Nozzle

Fixing a Airbrush Broken Fluid Nozzle Fixing a airbrush broken fluid nozzle tutorial covers fixing a screw in type airbrush fluid nozzle that was broken due to over tightening. It doesn’t take much to snap a fluid nozzle off during nozzle replacement and this how to article covers how you go about fixing that. Written by Don Johnson, airbrushgallery.com brought to you by Airbrush Technique Magazine.  “Break that airbrush tip or nozzle off did you?” Well don’t feel alone anyone who has used an airbrush with a screw in tip (picture #1) for any length of time has most likely done Read more